In this session of A Few Easy Steps, we will Setup a Loopback address on a Cisco Switch.
In General this will work on any L3 Cisco IOS Device.

Session Prerequisites:

• You have a Cisco Console Cable
• You have a serial port
• You have a Terminal Program that you can access your Serial Port

Session Assumptions:

• We are setting up Loopback0
• The IP Address is 10.92.254.1 /24

Our goals of this session are:

• Create Loopback Interface
• Set IP Address

Create Loopback Interface

!
conf t
!
interface loopback 0
!
no shut
!
end
!
copy running-config startup-config

Set IP Address

!
conf t
!
interface loopback0
!
ip address 10.92.254.1 255.255.255.0
!
end
copy running-config startup-config

Find out more about LoopBack Interfaces in Cisco IOS here.

or

Check out this Search at NetworkSuperSearch.com.